08-Jul-2016 10:45

Causes of Problems with Firmware for Hybertone GoIP

goantifraud goip

Beginners often have problems with firmware for hybertone GoIP. They face problems all the time - from the loading to the stage of equipment response to calls.

Problems can arise in the following cases:

  1. In the beginning, when you are downloading the firmware version.
  2. When there is a certain firmware version that needs updating.
  3. Difficulties start during the boot when there is information about the presence of errors, or the system indicates that it does not see the right gateway. After flashing, the gateway may report that ports are not found or are not registered.

    Terminators, who are trying to understand the installation and configuration of equipment on their own, have such problems, which are fraught with the loss of time and therefore money. There are cases of the incorrect choice of the firmware version, using the links from manufacturers or counselors from the forum. As a result, the novice mistakenly downloads a version that is not suitable for further proper operation of the equipment.

    Expand capabilities of
    GoIP equipment by connecting it to GoAntiFraud! We provide proven tools to increase the efficiency of GSM termination. Our service will help extend the lifespan of SIM-cards, computerize workflows, and remotely manage GoIP equipment from anywhere in the world.

    The fact is that inexperienced terminators do not always distinguish subtleties of downloading and configuring the relevant firmware version. For example, when you install the SIM-bank, GHSFVT-1.1-26, GS-4.01-67, SMB-1.01-26, SMBT-1.01-7 are usually used while the SIM-server requires V1.7.1. GoIP 1 needs GHS-3.01-53, GoIP-4 - GHS-4.01-25, GS-1 - GS1HSFVT-1.1-21, and GoIP-4 - GH-4.01-94 etc.

    Tones and noises sometimes occur in the GHS-3.01-46 firmware for GoIP. Some terminators advise downloading the 47 version when such failures happen. At the same time, such activities are not always efficient. Even if the flashing is carried out normally, then a failure and suspension may occur in the SIM server gsm gateway system.

    Similar problems occur in the second case when you have to update the older version. According to the Hybertone Ltd official website, sometimes there is a problem updating the firmware. Wrong actions usually result in system hardware error. Consequently, the devices do not function normally.

    A correct solution is the GoIP firmware via GoAntifraud. To download it, you need to visit the site and add a gateway, and then, seeing the Gateway display button - press it. That is all you have to do because the GoAntiFraud system handles it for you!
    business
784
0/5
0
votes

Related Articles

GoAntiFraud

How to Solve a Problem of Losing GSM Gateway Channels When Terminating

03 Oct 2016 09:50
Many terminators are faced with the loss of GSM gateway channels. This is especially true of inexpensive Chinese equipment. For a while, all the channels are functioning properly, and then some of them start "falling off" with an arbitrary frequency, that is, they lose registration in GSM networks. ...
GoAntiFraud

Setting up GoIP Gateways to Work with Elastix. Key Features

16 Jun 2016 08:49
The GoIP gateways are well proven as equipment for GSM traffic termination. The good functionality of the devices is successfully combined with their attractive price. To successfully start a business using the GoIP-gateways, you should set up the equipment. We will look at how to connect the gatewa...
GoAntiFraud

Review: GoIP 16 port gsm gateway

02 Dec 2015 14:24
VoIP GSM Gateway GoIP 16 is a multifunctional device that integrates 16 channels. It meets GSM and IP standards. It is designed for quick connection of call-center to the GSM network. Primarily, this is made possible by simultaneous routing of a large number of calls to the lines, including SMS and ...
GoAntiFraud

The Gateway with the Built-in SIM-bank for GSM-termination

15 Jun 2016 08:51
The SIM-bank is a must for every terminator, who seeks to expand his business. This device allows you to keep a lot of SIM cards, as well as perform a virtual relocation of cards among several gateways. You can move them by hand because each SIM-card slot is tied to the gateway channel. You can also...
GoAntiFraud

Start of Work With VoIP Equipment

22 Aug 2016 15:08
Beginners, who are familiarizing with VoIP technologies, do not yet know many nuances of the organization of the Internet telephony. Some of them are willing to save and connect the Huawei 3G modem of series E1550, E160g, E173, and E1752C. But, according to experts, it is better to install the gatew...
GoAntiFraud

GoIP GSM Gateway 4 is the Best Choice to Begin GSM Termination

03 Oct 2016 10:06
If you are just planning to start a GSM termination business, you have to consider a lot of nuances. In addition to the selection of the country to profitably invest in, the search of traffic suppliers, installation and configuration of specialized software, you need to give due consideration to the...
GoAntiFraud

Selecting the GSM gateway for Termination: GoIP vs China Skyline

20 Jul 2016 12:19
Beginners in the VoIP termination business have a problem of choosing specialized equipment. The first and most important thing that you need is a GSM gateway to land international traffic at local rates. The most popular and low-end solution is China GoIP gateways. EjoinTech & China Skyline are...

GoAntiFraud

GoAntiFraud GoAntiFraud GoAntiFraud GoAntiFraud GoAntiFraud GoAntiFraud GoAntiFraud GoAntiFraud GoAntiFraud
GoAntiFraud GoAntiFraud GoAntiFraud GoAntiFraud GoAntiFraud GoAntiFraud GoAntiFraud GoAntiFraud GoAntiFraud